AV REALITY - Audiophile High-End Music Loudspeakers / Lautsprecher / Luidsprekers / Højttalere for high-fidelity / home entertainment / home theather / Audio equipment, Exotic tweeter and bass driver units from Scan Speak, Vifa woofer unit for DIY, 3D, ONE, transparency, dynamic sound, acoustic design and technology, International online Sales

Diy Three

Complete AVinci Three DIY Kit with
the Ring Radiator and the Premium Line units from Vifa:

Now with new crossover and ultra high quality crossover components.

The kit contain everything, including assembled cabinets and assembled loudspeaker cloth frame.

NO woodwork on the AVInci Three - everything is ready!
We have made the very complicated hole to the tweeter and the hole to the bass unit, the port and the connector plate.

You must be able to solder, to glue the mid/bass unit with rubber glue and use a screw driver.

How to assemble the crossover?
Click picture to see the quality parts.

1. The resistor is connected between the upper two terminals.
2. The input from the amplifier is connected to the two lower terminals.
3. You can shorten / by-pass the capacitor: Add only one jumper, on the ground side to (Input -).

Mount the crossover in the bottom of the cabinet using four screws.
Afterwards mount the connector plate and resistor on the rear side of the cabinet

When the crossover is mounted then you have to insert the damping material into the cabinet and mount the driver units. Insure you are connecting the wires from the crossover to the correct terminals of the units.